Good afternoon, I've been searching the forum and can't find support on this.


I think I don't use the RTK equipment well (or it has a problem).


I have measured a surface with the BS at one point and to measure another part of the farm I have had to move the BS to the other end and I have marked it at an intermediate point (marked by a stone) at both.


The problem was that when passing the file to the station there is a difference with the marked point (the stone) of about 2-3 meters ... any suggestion or manual for using the RTK (version 1)


Thank you!

Image of the points

Hi, you need imput manually the coordenates via RC to the system, after 15 minutes with reading RTK2, then reboot rc and aircraft.  You need mark in the floor with rock or better with another stuff to prevent move it accidentally, its necesary install RTK2 in the same point again and again and imput the corresponding coordinates.