Hi all
I want to use a servo motor controlled by the PWM outputs of the Matrix 210 RTK V2. But I'm having a number of problems: 1) PWM servomotors use a voltage ranging from 4.8 to 6 Volts, while the Matrix 210 (it is also written in the manual) uses a voltage on the PWM pins of 3.3 Volt 2) On the manual I find written: "PWM power level is 3.3V and all pins can be configured in DJI Pilot app". But this is not possible, or at least, after updating the Pilot app a few days ago, I can't find any way to configure any pins.
Can anyone give me a tip? Or can you tell me where to find information?
I have searched the web and in this forum but have not found anything.
My servo motor expects to be updated every 20 ms with a pulse between 1 ms and 2 ms. Duty cycle is a 50 Hz waveform.
With a 1.5 ms pulse, the servo motor will be at the natural 90 degree position.
With a 1 ms pulse, the servo will be at the 0 degree position. With a 2 ms pulse, the servo will be at 180 degrees.
But I have not results: the servomotor does not move!
Thank in advance who will want to help me.
Best regards,
Simone
|