Thank You sploodge for staying on top of this. "REMEMBER TO UPDATE THE CONTROLLER TOO, DJI HAVE CORRECTED THE RELEASE NOTES TO REMOVE REFERENCE TO NOT UPDATING THE CONTROLLER!!"
So you update the P3 and leave it turned on and update the controller?
"Updating the Remote Controller Firmware Step 1- Check Battery and SD Card Capacity Remote controller firmware is included in the aircraft firmware update package. Use the same update package file that is downloaded from the DJI official website. Ensure that the remote controller battery level is above 50%. Step 2- Prepare the Firmware Update Package 1. Extract all downloaded files into the root directory of an SD card or USB thumb drive. 2. Insert the SD card into a SD card reader or the USB thumdrive onto the remote controller USB port when remote controller powered off. If you do not have a SD card reader, you may insert the SD card into the gimbal and connect the gimbal with remote controller to upgrade the remote controller. Step 3- Update the Remote Controller 1. Power on the remote controller and wait 60 seconds until the upgrade begins. Do not power off the remote controller during the update. 2. It will take approximately 10 minutes to complete the firmware update. The camera will sound a beeping sound and the Status LED on the remote controller shows solid blue to indicate the update is in progress. The Status LED on remote controller shows solid green and beeping sound will stop if the upgrade is completed with success. The Status LED on remote controller shows solid red if upgrade is failed. Try upgrade again."
|