Please select Into the mobile phone version | Continue to access the computer ver.
Motors won't start
609 1 4-19 12:09
Uploading and Loding Picture ...(0/1)
o(^-^)o
niacuadala
lvl.1

Spain
Offline


Hi everyone, so I had this quadcopter for a long time and now with the quarantine I had some time to ensable it. It is the first time at all that I deal with a copter.I have a naza-m that I was able to connect to my PC. It is upgraded with the last firmware (4.02) and I was able to calibrate, test motors, everything. The TX is a Turnigy 9X that I also managed to configure.issue I have now is that the motors won't start. The naza keeps blinking twice in yellow. According to the manual,
http://dl.djicdn.com/downloads/nazam-v2/en/NAZA-M_Quick_Start_Guide_v1.24_en.pdf
It means that sticks are not at center, but as said, I have calibrated all and sticks are centered.

If I switch to manual mode, led stops blinking but cannot start motors anyway.

I am out of ideas, any help very much appreciated.



Here's a video of all my setup:
https://youtu.be/6lwaUuE9Yvs

4-19 12:09
Use props
Vlas
Captain
Flight distance : 1337851 ft
  • >>>
United States
Offline

Have you tried a reset?
5-3 11:55
Use props
Advanced
You need to log in before you can reply Login | Register now

Credit Rules