Hello friends,

I have a question for the experts among us. I would like to swap the upper part of the gimbal module - see attached picture. I thought it's being held together by a single screw (red circle), but removing it doesn't seem to loosen it. Any ideas?
Thanks!

Hello, did you find a solution to this dilemma? I am also interested!

djiuser_F4TBrCPBYlNl Posted at 9-2 06:35
Hello, did you find a solution to this dilemma? I am also interested!

Unfortunately not. Swapping the whole gimbal seems to be the only option.

have a look here

Droneflier Posted at 9-2 09:31
have a look here

Thank you, the video is very helpful! However that exact connection I'm interested in isn't covered there. But maybe I can find a workaround.

Late but here is how  to dissasembly:

https://youtu.be/em7qHh0jALI

djiuser_jZElbzvkKfnV Posted at 1-9 14:22
Late but here is how  to dissasembly:

https://youtu.be/em7qHh0jALI

Is that your video?

Found the tool on aliexpress btw https://www.aliexpress.us/item/3256804193937386.html?gatewayAdapt=glo2usa4itemAdapt&_randl_shipto=US
60 bucks

Buying the new plastic is cheaper, but I need the coded imu board or whatever it is to transfer.