I just replaced the ribbon cable on my camera gimbal. The camera works fine, but Gimbal Calibration stops at 68%. Up to that point everything seems to move just fine. Then it freezes at 68%. Is this a gimbal issue or a ribbon issue or something else?
Eralp SAYGIN Posted at 5-7 14:43
Is there any notification like "Gimbal Motor Overloaded" ?
No. No error messages other than gimbal calibration would freeze at 68%. I was able to finally fix the problem by simply replacing the camera IC board.
FalconJetCaptain Posted at 5-12 13:02
No. No error messages other than gimbal calibration would freeze at 68%. I was able to finally fix the problem by simply replacing the camera IC board.