I just replaced the ribbon cable on my camera gimbal.  The camera works fine, but Gimbal Calibration stops at 68%.  Up to that point everything seems to move just fine.  Then it freezes at 68%.  Is this a gimbal issue or a ribbon issue or something else?

Hi FalconJetCaptain, sorry for the trouble with the gimbal, we do not recommend to repair the drone by yourself since more issues could happen and the performance cannot be ensured after the repair. You may try to refresh the firmware. If the issue persists, it is recommended to send in the drone for the evaluation. Please contact our support team www.dji.com/support for further assistance.

Boa noite Falcon! Fiz a substituição e ocorreu o mesmo problema e mais alguns!  conseguiu resolver o problema dos 68% ?  O outro problema é que o vídeo que faço está com a imagem tremula! fotografia ok!  Já passou por isso? Será que é interferencia magnetica? Detalhe o problema acontece também quando está no solo!