Hi

I can find loads of posts on this but no real solutions.  

I am using an Eos R on the Ronin S with the latest firmware.

I have:

• Balanced the camera/lens correctly (all reported Excellent on the Balance Test)
• Run Auto Tune
• Calibrated the joystick with the 4 trigger press method
  

But every time the gimbal will drift by panning to the right, sometimes straight away but always after ANY joystick input.

Checking Channel 3 it shows random input values.  

I strongly suspect a physical fault.

Before I return the unit, any suggestions?

Thanks



Mark

This is without any joystick input and after the joystick has been calibrated

Hi there, I'm sorry to hear about the difficulties that you encountered. Could you please record a video to show us the details of the issue? I'd like to help you check it, thanks.

DJI Natalia Posted at 5-24 23:39
Hi there, I'm sorry to hear about the difficulties that you encountered. Could you please record a video to show us the details of the issue? I'd like to help you check it, thanks.

I have the same problem

I also have the same problem on channel 3.  Panning right

It went back to DJI for repair and they replaced the joystick unit. Works ok now but the Customer Service experience is very patchy.

Same issue here... digging through forum posts in hopes of finding another way to fix mine before resorting to sending it in for repair.... I hadn't noticed the Channel 3 variation, but mine was all over the place like I was moving the joystick.