HI Folks,
I guess this is an esy thing to cure, sometimes when i go to my site to fly, i switch on the TX the light is Red and then i switch on the Drone, sometimes it connects fine and other times it will make a loud beep sound and vibrate, i am also unable to swtich of TX, so i switch off the Phantom , then swtich off TX,
i then do the same procedure again sometimes it works and sometimes i have to reboot both, normally after 2 or 3 attempts it will be fine, the light on TX is green, and on the app it says ready to go..

What i find confusing is when the tx is red and sounding an alarm and vibrating, the screen within the app shows green and ready to fly...

Do i need to rebind both tx and drone ? i have had them both checked over and there is nothing physically wrong with both drone and tx.

HI Folks,
I guess this is an esy thing to cure, sometimes when i go to my site to fly, i switch on the TX the light is Red and then i switch on the Drone, sometimes it connects fine and other times it will make a loud beep sound and vibrate, i am also unable to swtich of TX, so i switch off the Phantom , then swtich off TX,
i then do the same procedure again sometimes it works and sometimes i have to reboot both, normally after 2 or 3 attempts it will be fine, the light on TX is green, and on the app it says ready to go..

What i find confusing is when the tx is red and sounding an alarm and vibrating, the screen within the app shows green and ready to fly...

Do i need to rebind both tx and drone ? i have had them both checked over and there is nothing physically wrong with both drone and tx.