Overview：

• Released Date: 2020.06.04
• Aircraft Firmware: v01.00.01.09
• Remote Controller Firmware: v01.00.01.08
• Pilot App Android v1.8.0R
• D-RTK 2 Mobile Station:v03.00.00.13
• Intelligent Battery Station: v01.05.06.04
• Intelligent Fight Battery: v01.02.05.22
• Zenmuse H20 / H20T: v01.00.01.08
• Zenmuse Z30: v01.00.06.10
• Zenmuse XT2: v01.00.03.50
• Zenmuse XT S: v01.00.00.09
• DJI X-Port: v01.01.01.00
• DJI Assistant 2 For Matrice: v2.0.11
• Firmware Upgrade Method:
  

      Aircraft / Remote Controller / D-RTK 2 Mobile Station: DJI Assistant 2
      The built-in DJI Pilot app: will be updated with the Remote Controller firmware
      Gimbal and Camera: microSD card
      Intelligent Battery Station: App (Connect the Battery Station to the remote controller and update it on the HMS page in the DJI Pilot app.)

What's New?

Aircraft Firmware

• Fixed the issue where the RTK positioning data is difficult to converge or the convergence time is too long in some areas.
  

Notes

• Make sure that the aircraft, remote controller, battery, D-RTK 2 mobile station (if used), payload (if used) are updated to the latest firmware version.
• Download the latest firmware from official website to microSD card to update the ZenmuseZ30, XT S, XT2 or H20 / H20T.
• It is required to use the DJI Pilot app built-in the remote controller, or download the app of V1.8.0R or later.
  

very well. Good news. One of several issues less (see m300forum). I hope Dji tacklles the other issues as well asap , including some hardware upgrades. will test it tomorow.

The M300 cannot find the D-RTK 2 Mobile station with this release!

DFL_SIMBA Posted at 6-9 11:22
The M300 cannot find the D-RTK 2 Mobile station with this release!

Never mind. Just had to update the controller

I have not found a user manual for the DJI Smart Controller Enterprise, Trying to see what the 3 different flight planners do in regards of altitude changes and how to configure start point.....