Thomas V
lvl.1
Netherlands
Offline
|
Hi,
I'm looking to bind my FPV Goggles and Controller to a second Air Unit. The first one is fine and running well.
I'm running into an oddity though, the Goggles don't seem to enter bind mode as far as I can tell.
Here are the steps I'm following:
- Action: Power on the air unit, goggles, and remote controller.
- Action: Press the link button on the goggles.
Expected response: goggles will start to beep continually. - Action: Press the link button on the air unit when the linking status indicator is solid green.
Expected response: The indicator will turn solid red when the air unit is ready to link.
At step two, the response from the goggles is a single beep at the moment I press the button. I've tried a short press, and longer presses powering the system off between tries. I always get a single beep.
Has anyone encountered this before? Is there something I could check, change or do to get it to act as it should?
Configurations etc:
- Air Unit Firmware: v01.00.05.00
- Goggles Firmware: v01.00.05.00
- Documentation checked: DJI FPV User Manual v1.2
Thanks.
|
|