Hi,
Wondering if anyone could help with this

Was doing a job yesterday, everything was working fine, not problems
On what was to be the last flight, I changed the battery pack in the drone as normal, turned it back on, and it would no longer transmit video from the x7 to the controller.
it wasnt dropped, it didnt happen in flight, not landed hard, etc etc

Im still getting the video feed from the FPV camera to the controller, but nothing from the main camera (video feed or histogram)

Any ideas whats the cause or if its a straight fowards fix?

Thanks
Michael

Did you try reseat the camera ?

flyingfun Posted at 6-12 00:45
Did you try reseat the camera ?

Hey,

Yeah, so far tried re-seating the camera, changing the lens, wiping the contacts between the camera and body, re-seating batteries, different batteries, restarting the controller/crystalsky, re-pairing the controller.

Did you try to remove the lens and back on ?

flyingfun Posted at 6-12 05:48
Did you try to remove the lens and back on ?

Turned out it was water damage to the processor on the drone was causing problems.

I sent it back to DJI and had it replaced

Hi everybody,
i ave the same problem as described above, I try whole solution as Mike 9129, nothing happened
what should I do?
thank you

Gazza1973 Posted at 1-6 09:01
Hi everybody,
i ave the same problem as described above, I try whole solution as Mike 9129, nothing happened
what should I do?

Do exactly the same: open the repair ticket with DJI ...