Yesterday I was doing some monthly mapping missions and I decided to use the M200v1 with X5S in case it started to rain toward the end of the mission.  (normally use the P4P)   On the first flight the M200 was flying north and south and when it was flying south about 1/2 into the mission it started vearing off the path a good bit.  I finally stopped the mission and switched back to the P4P.  I recalibrated the compass on the M200.  There were no warning messages in DroneDeploy when I was flying with the M200, it just simply flew off the automous mapping route.  Unfortunately the screen capture of the route did not take.

The M200 is on the latest firmware and so are the batteries.


At another site, I flew with the M200 again and it this time the path from Northwest to Southeast.  It only veared off the taget path when flying NW.  I have a screenshot from my iPad Pro showing what it did.  The photos geodata corelate to this same path.  

Can anyone tell me what is going on with this?  Today I hope to have time to test it again but with a different flight planning app and at a different location to see what happens.   Any help will be appreciated.

Tim

I had same problem Matrice 210 D-RTK V2..Anyone for help!!

When did you have the problem with your m210?  I have flown two test flights after this happened and I have not been able to replicate the problem. however I have not gone back to the location where it happened. I hope to do that in the next several days and see if it happens again at that location.

I am a user of Matrice 210 D-RTK 2 V2. I had this problem last 1 week. Anyone for help ?

+1 had this issue recently during an inspection. I thought using the DRTK would assist odd location issues, not provoke them...