Hi,

after the update to the latest FW my focus wheel stopped working (I use it without the motor).
The LED of the focus wheel flashes two times red. ( Double red blinking: the module requires a firmware update - https://dl.djicdn.com/downloads/ ... t%20Information.pdf)

How to update this again?!

To fix this:
Add the focus motor, the app will tell you that there is an update (specially for the part that hasn't been updated).

Also: Focus wheel flashes 2 times red if you turn a too long screw on the other side too deep inside... that can cause a short circuit on the contacts...! :-)

Hi Im having same problem after updating my ronin s today I wish I have never did that!!How did you fix that?

Start ronin and the app on the phone and you should get a notification that new firmware is available , on your phone ( top left corner) Good luck

Hello . Have you found any sollution for this ?