bachellerieloic
New
Canada
Offline
|
Hi, I recently bought a Mavic 2 Pro and after using it a couple of hours, I wanted to try the Active Tracking... that resulted in a small crash.
I now get the message : Esc Status Error, Turn off aircraft and restart ...
I have a hard time believing it's an ESC issue because whenever I turn on the drone, there is the normal 4 beeps and each motor turn a few degrees following the beep sound.
(On the 4th beep, no motor is turning, I don't remember if it is normal).
Also No motor show any kind of resistance, they all spin freely.
I tried upgrading the firmware since it wasn't the latest, but nothing has changed.
I was reading that someone downgraded his firmware and got rid of ESC status error.
On this thread (Phantom) : https://forum.dji.com/thread-103582-1-1.html the second post says to "put the firmware on the micro sd card and insert again"
and https://forum.dji.com/forum.php?mod=viewthread&tid=120384 they upgrade the firmware and are able to get rid of these issues.
Anyone is in the same situation ? Could it be a calibration issue after a shock ?
Thanks!
|
|