Hi
I like to use Point of Interest but have a problem when I try to set another POI after completing the first one.
I finish the POI by pressing on the red cross on the app screen and then hold the pause button on the RC.
When I try to set another POI I get a message on the app screen saying quit current task.
I thought I had.
I have tried changing flight modes, S, T and P
I have tried using another intelligent flight mode, cinematic
I have tried switching off the Mavic 2 Pro and the RC
None of the above get rid of this message.
Looking at the manual it says to exit press and hold the pause button on the RC.
Can anyone help me with this, what I would like to do is shoot some video of one point of interest and then choose another point of interest and shoot it and repeat this until I have all the shots I need.

Thanks

John

Edited for an update
I have deleted the GO 4 App and reinstalled it
I can set a POI by using GPS positioning method but when I try to select the point of interest by drawing a box on the screen I get the message current task quited (not quit current task)
I have the latest verson of the firmware and the latest version of IOS on my iPhone(XR)

Edited for another update
I decided to buy a Smart Controller my original controller became faulty and I had a lot of work to do.
I tried Ponit of Interest using the SC, it worked fine.
I then set another POI by drawing another selection, again it worked fine.
I went on to do this several times and each time it worked.
I can only assume there was a problem with DJI Go 4 and my iPhone XR

Hi
I like to use Point of Interest but have a problem when I try to set another POI after completing the first one.
I finish the POI by pressing on the red cross on the app screen and then hold the pause button on the RC.
When I try to set another POI I get a message on the app screen saying quit current task.
I thought I had.
I have tried changing flight modes, S, T and P
I have tried using another intelligent flight mode, cinematic
I have tried switching off the Mavic 2 Pro and the RC
None of the above get rid of this message.
Looking at the manual it says to exit press and hold the pause button on the RC.
Can anyone help me with this, what I would like to do is shoot some video of one point of interest and then choose another point of interest and shoot it and repeat this until I have all the shots I need.

Thanks

John

Edited for an update
I have deleted the GO 4 App and reinstalled it
I can set a POI by using GPS positioning method but when I try to select the point of interest by drawing a box on the screen I get the message current task quited (not quit current task)
I have the latest verson of the firmware and the latest version of IOS on my iPhone(XR)

Edited for another update
I decided to buy a Smart Controller my original controller became faulty and I had a lot of work to do.
I tried Ponit of Interest using the SC, it worked fine.
I then set another POI by drawing another selection, again it worked fine.
I went on to do this several times and each time it worked.
I can only assume there was a problem with DJI Go 4 and my iPhone XR