I have a Naza M V2 with 4.02 Firmware and Naza Assistant 2.40. I can connect to the assistant software, I can calibrate everything stick movements are fine, can start the motors  and have full throttle range, and everything in the assistant checks fine, but I then take the quad outside and restart, wait for all the correct led lights start the motors but motors do not increase revs until past the halfway point and then they want to propel the quad skyward like a spaceX rocket trying to leave Earth and I have no rudder aileron or elevator functions even though they were fine connected to the assistant. I am using a flysky FS-TH9X transmitter and receiver, setup of the assistant is the receiver as traditional . I tested the receiver with a servo and all outputs work fine, just not with the Naza M. I am starting to get desperate so any help will be most appreciated

I have a Naza M V2 with 4.02 Firmware and Naza Assistant 2.40. I can connect to the assistant software, I can calibrate everything stick movements are fine, can start the motors  and have full throttle range, and everything in the assistant checks fine, but I then take the quad outside and restart, wait for all the correct led lights start the motors but motors do not increase revs until past the halfway point and then they want to propel the quad skyward like a spaceX rocket trying to leave Earth and I have no rudder aileron or elevator functions even though they were fine connected to the assistant. I am using a flysky FS-TH9X transmitter and receiver, setup of the assistant is the receiver as traditional . I tested the receiver with a servo and all outputs work fine, just not with the Naza M. I am starting to get desperate so any help will be most appreciated