Hi All:

There are issues with the X-T3 (firmware 3.21) and Ronin SC Firmware version 1.5.040.  This is what I have obsevered:

• Camera in movie setting setting, attached to Ronin SC, turn camera on.
  

      - Record button works as expected.
       - Change camera to single shot mode:
               - Pressing record on Ronin SC does not function.

• Camera in single shot mode, focus mode set to S, attached to Ronin SC, turn camera on.
  

       - Half Press of record button results in focusing of camera
       - Full Press of record button results in camera taking image.  However, there is delay in camera taking image and the record button must remain pressed until an image is taken.
         Image should be taken immediately and record button should not have to remain depressed to get an image taken.
       - Switch camera back to movie mode without first turning camera off.
              - Camera remains in single shot mode.

In general, camera must be turned on with intended purpose set (movie or single shot) for the record button to work as designed.  I am not certain if these issues are the result of the firmware of the X-T3 or the firmware of the Ronin S.  Maybe an interaction of both.  But something is not right.

Hope this helps others and DJI/FujiFilm in improving their firmware.

Sincerely,

Don Barar

That is a Fujifilm thing, they are trying to get better, but they are not yet at the highest point they can be.