Hello, after a flight and wanting to shut down the battery of the Air2, the pn battery lights started to turn (see video) can someone tell me what that means?

Hi. Thank you for reaching out to DJI Forum. With regards to this concern. Kindly please relink the remote controller and the DJI Mavic Air 2 and after this process is done the battery LED indicator will show the battery capacity as usual. Please refer to the official DJI tutorial video I have posted below for the linking process for the DJI Mavic Air 2. Thank you.

DJI Paladin Posted at 8-13 10:10
Hi. Thank you for reaching out to DJI Forum. With regards to this concern. Kindly please relink the remote controller and the DJI Mavic Air 2 and after this process is done the battery LED indicator will show the battery capacity as usual. Please refer to the official DJI tutorial video I have posted below for the linking process for the DJI Mavic Air 2. Thank you.

https://www.youtube.com/watch?v=YqAjZQfMhNA

Good info - thanks for sharing as never knew that

DJI Paladin Posted at 8-13 10:10
Hi. Thank you for reaching out to DJI Forum. With regards to this concern. Kindly please relink the remote controller and the DJI Mavic Air 2 and after this process is done the battery LED indicator will show the battery capacity as usual. Please refer to the official DJI tutorial video I have posted below for the linking process for the DJI Mavic Air 2. Thank you.

https://www.youtube.com/watch?v=YqAjZQfMhNA

Is there something about that procedure in manual ? Because I don't see this

You may have held the battery button down too long and it went into pairing, I think.  To turn on or off only hold for two seconds after the first tap.  Pg26.

1piotr13 Posted at 8-13 11:03
Is there something about that procedure in manual ? Because I don't see this

Linking is on page 35.

A J Posted at 8-13 10:13
Good info - thanks for sharing as never knew that

You are more than welcome and thank you for your valued support.

DJI Paladin Posted at 8-14 10:02
You are more than welcome and thank you for your valued support.

.

Thank you very much for this information. I had seen nothing in the manual concerning these turning LEDs

Thanks for the info! Did this by accident yesterday,and wondered what it was..

Rustic17 Posted at 8-13 12:18
Linking is on page 35.

The author of this post didn't say that this is new controller. The manual mention about linking new controller.

1piotr13 Posted at 8-17 03:24
The author of this post didn't say that this is new controller. The manual mention about linking new controller.

You’re right but in reply #4 you ask if there’s any thing in the manual about the procedure. Linking or pairing can be used for a new controller or if the pairing is lost in your current setup. The OP didn’t need to link but I thought he might have accidentally gotten into the linking process by holding the battery button too long attempting shutdown.  That’s why I mentioned the procedure.

It's exactly that.