effedebe
New
Belgium
Offline
|
Hi everyall,
I'm new on forum, and my english is very relative, but can you help me
After the Phantom 3 se is crashed,
I do replace :
- several mecanics parts of cameras
- connector cable from camera to square card under drone
- Solder woth connectors of camera on this same card.
now drone ask to me to update firmware, but it is not possible because it is disconnect each 13 seconds during 5 seconds
( this connection is lose with android and with command sticks )
update will stop about 20% because connection is loss.
I think all is work except this connection, because:
- it is image from camera a short time
- It is possible to fly 10 seconds
Another thing :
3 motors axis of camera and camera itself are very hot
and the start postion setup of camera is not done.
Is someone have an idea to restore stable communication ?
May i replace card of camera ( this one where is connected antennas ) ?
Very thanks you to help me ! (if it is possible .. )
|
|