Got my new Ronin-SC a short time ago and have it set up with my Nikon Z6. I have done balance test and it's good. However, when I turn corners the gimble is slow to respond. For example, if I walk straight ahead and then make a slow 90-degree turn to the right the gimble will follow but very slowly. It will lag about 45 degrees until it eventually comes to the point of pointing in the same direction as me. I've tried adjusting the motor settings for panning, but it seems to make little difference. I can kind of compensate using the joystick but this can often result in an overcorrection unless I get the timing of the joystick just right. Any ideas how to fix it??
Thanks for the help.

Got my new Ronin-SC a short time ago and have it set up with my Nikon Z6. I have done balance test and it's good. However, when I turn corners the gimble is slow to respond. For example, if I walk straight ahead and then make a slow 90-degree turn to the right the gimble will follow but very slowly. It will lag about 45 degrees until it eventually comes to the point of pointing in the same direction as me. I've tried adjusting the motor settings for panning, but it seems to make little difference. I can kind of compensate using the joystick but this can often result in an overcorrection unless I get the timing of the joystick just right. Any ideas how to fix it??
Thanks for the help.