PHREAKTOR
lvl.1
United States
Offline
|
When I update these new standard goggles via DJI Assistant 2 for FPV, The update process gets to 89%, thenthe goggles disconnect from the PC and reboot. The software then jumps to 100% and the version shows the latest in the software. When I click the Back button and click then the goggles icon, instead of taking me to the Activation prompt, it takes me right back to the Firmware list. The Firmware list shows as it did before as though the update did not take, but the goggle status shows they have the lastest firmware. The goggles and software continuously loops like this and I cannot activate the goggles. I am using DJI Asissatant 2.02 for FPV.
This is very freustrating because I JUST had to send in my AC and RC because the last update for the RC crashed in the middle of the update in DJI GO 4 and bricked the controller. I was initally sent a $430 bill for all kinds of unecessary repairs and DJI repaired it free of charge only after I complained that it was not my fault. Here I am again with another software issue with like new DJI goggles the first time using them.
|
|