Yes you possibly need to do a "Reset" of the RC and then re-link it to the AC. What you described was not exactly right, Resetting the controller and linking to the drone are two separate actions.
Reset the RC: With RC OFF, press and hold C1 & C2 at the back of the RC and the shutter button and keep them pressed while turning the RC on.
To LINK the RC/AC - Turn on the AC and RC and press the Link Button on the AC. This will turn RED waiting to link On the RC Press C1 & C2 and the Record button, the RC should BEEP. Let go the three buttons and pree the WHEEL on the RH side of the RC. The LH light on the RC should turn BLUE and the controiller will BEEP - . . - . . - . . (D in morse code) The RC will stop beeping and the Link button on the AC will turn GREEN if the link was successful. Alternately:
- Turn on the remote controller and connect controller to the mobile device you use to fly with.
- Launch DJI Pilot app.
- Turn on the aircraft Intelligent Flight Battery.
4. On remote controller enter “Camera” and tap on the image of a remote controller and five bars. 5. Locate the linking button on the side of the aircraft and press it, it will start blinking. The Remote Controller Status Indicator will display solid green once the remote controller is successfully linked to the aircraft.
|