Running into a strange issue today with my Inspire 2/X7 kit. I have two controllers, one master, one slave. Today on my master contorller I cannot control the gimbal with the sticks. The left front wheel on the RC works (only for tilting) but the sticks get no response, leaving me unable to pan. The gimbal/camera otherwise operate fine... touch autofocus, etc., operates normally. When I fire up the slave controller and take gimbal control, the slave works as it should, sticks and all.


I just finished upgrading firmware on the bird and both controllers and the problem persists.

Anyone have some insight here?

Thank you!
Adam

I may be missing something.  You control the gimbal with the sticks on the "master" controller while flying?