Drone-Pilot
 First Officer
Flight distance : 2131073 ft
United States
Offline
|
Marty Markoe Posted at 9-27 05:34
I sincerely feel your pain. I spent over five hours yesterday to finally get the new firmware to take on the smart controller. Frankly I do not even recall exactly what I did as they were so many different things. However, here I will try to help you. After getting start at the 99% and then several no network connection errors, I went out to the internet to look for Solutions. Among these were to remove the SD card. There were several suggestions on during the update from your computer wish I'd had been doing as well as through the wireless on the smart controller. Repeated attempts at the update on the internal smart controller memory kept getting filled up by not removing the attempted update. This was causing insufficient memory messages. Finally I restored the smart controller to its original configuration. I believe I had tried that a couple of times but with a reboot ofor smart controller ito worked. Note, you will need to reset all of your gimbal and camera settings.
Thanks for your response. I've been at it for the past two days with a major headache and half a bottle of Tylenol already gone So it's normal to get the message that shows in the picture? |
-
|