Hello,

I am a graduate student in electrical and computer engineering at the University of Texas at Austin. We are developing a custom payload for the M300.

We are trying to use a third-party development board with the Skyport V2. I understand I need to connect to the UART port on the PSDK adapter board. What is the voltage level and baud rate of the adapter board’s UART interface?

I’ve been referencing the information here: https://developer.dji.com/payload-sdk/documentation/quickstart/device-connection.html

Is there a more complete set of documentation I have not found?

Thanks,
Will

Hi!
You might be better off posting your question in the 'products' section of this forum.
That is way more active.

Montfrooij Posted at 10-9 00:39
Hi!
You might be better off posting your question in the 'products' section of this forum.
That is way more active.

Thanks, I'll head over there.

willlies Posted at 10-13 04:49
Thanks, I'll head over there.

You're welcome!