seedjar
lvl.1
United States
Offline
|
My FPV Remote doesn't seem to change signals on any channels no matter how I set it up in the configuration menu on the goggles. Neither the gimbals nor switches seem to be recognized. The same goes in BetaFlight - there is no change on any channel regardless of what position the inputs are in. The gimbals respond in calibration mode, so I doubt it is a mechanical issue.
I've followed a few threads similar to this issue but haven't found a particularly definitive answer. I tried setting ARM to SA, and the arm setting popped up in BetaFlight, but I can't get it to respond to input. I know how to lock and unlock the controller with the C button, and that's not it.
FWIW, my FC stack is a T-Motor F7 Mini + F45 ESC. No extras installed aside from a buzzer. My motors respond fine to manual control in BetaFlight and everything appears to be normal otherwise.
I'm sure there's already a solution out there - if someone could point me in the right direction, I'd be very appreciative.
Thanks for your time,
~Joe
|
|