With the regulation that the FAA number must be on the exterior of the drone, why limit it to a bland sticker?
I got the bright idea to get a custom sticker made at Sicker Mule.
I'm sure there are all kinds of places out there that'll do it, but Sicker Mule made me 10 samples for $9, which isn't too bad, LOL!
I used my YouTube channel logo, and it really came out nice!
I ordered the die cut sample pack @ 2"X3". when it's die cut, the sticker fits perfectly on each side of the drone!

Thanks for sharing

Nice one

very cool.

Nice, thanks for sharing

A J Posted at 10-13 00:53
Thanks for sharing

I figure it looks nicer than just sticking a printed label on it, LOL!!! That’s what I had before, and it just looked so generic.

DAFlys Posted at 10-13 01:51
very cool.

Thanks! I figure it makes it look a little better, and hey, what’s $9?

A J Posted at 10-13 00:53
Thanks for sharing

I figured it makes it look a little better anyway, thanks!

Pretty cool!

I inkjet printed the information on a clear label, trimmed it and stuck it to my MA2. Then I put a piece of clear packing tape over it.

Hello there Kentucky_Ranger. Thank you for reaching out and for these interesting information you have shared. Again, thank you for your support and have a safe flight always.

Kentucky_Ranger Posted at 10-13 15:27
I figured it makes it look a little better anyway, thanks!

You’re welcome

Kentucky_Ranger Posted at 10-13 15:25
I figure it looks nicer than just sticking a printed label on it, LOL!!! That’s what I had before, and it just looked so generic.

Kentucky_Ranger Posted at 10-13 15:27
Thanks! I figure it makes it look a little better, and hey, what’s $9?

Is that $9 each?

Kentucky_Ranger Posted at 10-13 15:27
Thanks! I figure it makes it look a little better, and hey, what’s $9?

Cheap as chips

DAFlys Posted at 2020-10-14 00:02
Is that $9 each?

I'm so sorry, I have been derelict in keeping track of messages on here.
That's for 10 stickers, not one.

Looks good!