Hi all,

I'm now flying the Spark for over two years. Altough... currently I have some issues. I've crashed the Spark a few weeks ago, unfortunately. Lots of damage, but mostly on the plastic parts. It seems that the motherboard and all the sensors were working fine, so I decided to give it a try and repair the drone by myself. I've ordered some parts at my Chinese friends and replaced the frame, top cover, gimbal brackets and the 4 motors (two were clearly damaged, but I thought it is perhaps better to replace all of them). Ofcourse I gave my Spark four new props also.

After switching on the drone, the drone didn't give me any errors. I've had GPS signal, could connect with the remote controller and IMU and compass seems nice. For sure ,I recalibrated the gimbal and compass without any problems. So time was there to start the motors. I've placed the drone on a flat surfaced and started the motors. But the drone seems a little bit instable. The noise of the motors was a little bit varying and the drone was 'wobbling/shaking' a little bit. See here: https://www.youtube.com/watch?v=67wquFQtulU

Is there anybody here who can give me advice what to do next?

Thank you in advance!

Hello fansa9a1dba2, It is unfortunate to know that your Aircraft crashed. I will recommend you to send your Aircraft for repair so that it can be properly tested and assessed the damages needs to repair. But just a quick reminder. We only have a year of warranty for Aircrafts and for some parts you can check this link for the warranty then select "Warranty Period of Main Parts": https://www.dji.com/service/policy?site=brandsite&from=footer

You can submit an online repair request through here: https://repair.dji.com/repair/index

Thank you.