5Yw10B2xdN
New
Germany
Offline
|
Hello,
I recently purchased a DJI FPV system to replace my old analog VTX. However, my first experience with it was far from pleasing. After 5 hours of searching and trying out I am still stuck with getting the Goggles to connect with the DJI Assistant 2 for FPV. The problem seems to come from the driver with does not install.
I allready followed the instructions to install the drivers manually as an admin with and without signature verification, but all in vain.
When I connect the Goggles, 5 new devices show up. Namely:
- Bulk interface
- RNDIS
- Unknown Device
- Unknown Device
- CDC Serial
The driver-device combination which seems the most promissing is the DJI USB Virtual COM on CDC Serial. However, as said, no success.
My questions are therefore: Why is this so damn complicated? How do you fix that issue?
|
|