Attempting to install a new camera Zen X5S I have to admit not real savy on this instalation.
Its aksing me to calibrate using a calabration board, where can i get a borad ? and do i need one or am i missing something here.

Thanks in advance

Mac

OH this is on an inspire 2

The calibration board comes with the drone. I don't think DJI sells it as a stand alone accessory. You could call some of your local DJI dealers and see if they have stock or try Ebay, Amazon etc.

The calibration board was supplied for obstacle avoidance sensors calibration and has nothing to do with X5S camera. Later the board was supplemented by computer screen equivalent, available in Assistant 2 software for Inspire 2. Use this method instead ...

Hello there Mac. Thank you for reaching out and for these information you have shared. You may try check our DJI Where To Buy platform on this link ( https://www.dji.com/where-to-buy ) to see if the said Calibration Board that you need is available and you may also contact our DJI Support Team at https://www.dji.com/support for further assistance as well. In addition, I hope that you can get some recommendations from our DJI Co pilots with regards to this inquiry. Thank you and please be safe always.