DJ GS Pro and Building Side Inspections

Need a way to cause interpolation between 2 points (overlap percentage).  Need a way to setup vertical heights doing like a horizontal orthomosaic but vertically so it goes left to right or right to left and on the next line it does the next column down or up.  Orthomosaics are horizontal doing say N then E to W then +1 S then W to E then +1 S W to E but for this I want it to be say 100 feet then goes left to right then down 5 feet and goes right to left then down 5 feet then goes left to right.  This can be done if we can have the program in 3D where the perspective can move around like a 3D camera instead of a fixed 2D one from the top.

This would be great for the enterprise area too w/o requiring a custom SDK or MFIO upload.

Not all inspections are to be done from the top.  Not all inspections have the luxury of space setting up a 360° POI.  Need it to be straight lines running parallel to exterior of the object or even a ship.  Not like a curved TV but a flat straight one.

Good luck with that

Have you thought about trying another product like Drone Deploy?

DAFlys Posted at 11-2 04:02
Have you thought about trying another product like Drone Deploy?

Good suggestion

A J Posted at 11-2 04:02
Good suggestion

Worth a go,  they have a 7 day free trial per email address you use.

DAFlys Posted at 11-2 04:08
Worth a go,  they have a 7 day free trial per email address you use.

Hahahahaha - most cunning - if you have several e-mail addresses

A J Posted at 11-2 04:10
Hahahahaha - most cunning - if you have several e-mail addresses

there are lots of places like sharkasers.com tht give you a disposable address without any signup.

DAFlys Posted at 11-2 05:27
there are lots of places like sharkasers.com tht give you a disposable address without any signup.

Never knew that - thanks mate

A J Posted at 11-2 06:00
Never knew that - thanks mate

Sorry mis typed that,  its sharklasers.com

DAFlys Posted at 11-2 07:34
Sorry mis typed that,  its sharklasers.com

DAFlys Posted at 11-2 04:02
Have you thought about trying another product like Drone Deploy?

I have used it extensively before but you can't do it w/ that either.  Not Pix4D, nor DJI GS Pro or DJI Pilot.