As title and attached photo says, today coincidentally, found out a thin plastic coating just next to one of the lanyard eyelet screw holes was cracked. Do not know, if this was caused because the pressure of eyelet screw or it was there since the beginning. SC is over a year old; I never ever over torque the eyelet and eyelets itself has also rubber gasket which normally absorbs and distribute the pressure. Plus, I also never stretched or tensioned the lanyard. It can be simply ignored , as apart from cosmetic, it does not impact function of lanyard attachments but just would like to know if either of DJI fellow has any similar defect or could this trigger further damage , such as loosening of the screw hole etc. Thanks in advance for your comments or advise.
|