Hi!

Leave a message because I have a question during development using a3!

I want to use TraceMode in the Waypoint protocol, but does a3 not support it?

After changing TraceMode to 0x01, Ack message is output when the mission is sent.
The message POINTS_NOT_ENOUGH is displayed.

However, sending TraceMode to 0x00 enables you to perform your mission.

Can I ask your reason?

How many waypoints have you set? If you set the "TraceMode" to 1, you must set an appropriate damping value.
How much do you set the dumping parameter?

kv886 Posted at 11-11 20:14
How many waypoints have you set? If you set the "TraceMode" to 1, you must set an appropriate damping value.
How much do you set the dumping parameter?

set the WayPoint between 5 and 10.
I didn't set the damping, but how much should I set it to?

Myeong Gyun Yim Posted at 11-11 20:23
set the WayPoint between 5 and 10.
I didn't set the damping, but how much should I set it to?

More than 0.2

kv886 Posted at 11-12 19:35
More than 0.2

"Not available now" is written in the Damping column, so if you enter a number in the column and send a mission, the following error occurs:

I see you use Qt. DJI has said that they will not update Qt anymore. I am afraid I can't help you because I don't use Qt. There are too many bugs in the SDK of the Qt platform