I have a Phantom rtk drone with a GL300N controller. The controller is a new replacement. I have connected the controller to DJI assistant 2 it shows the controller current with version V02.01.0012 but on the Android device it says new firmware, please update. The new update version is 02.02.0505. I hit update and it goes through the three steps and when it finishes it says successful update and the error "Update Failed. Error Code: 810" pops up, the new version did not install, it still shows the old version. Please help. It will not connect with the drone probably because of a needed update.

Welcome RB BAKER , i would use Dji assistant 2 https://www.dji.com/es/downloads ... t-dji-2-for-phantom

I have tried that too and it will not pull up the latest version but the built in android device shows too more version newer than what is showing on the assiatant.

RB BAKER Posted at 12-14 11:21
I have tried that too and it will not pull up the latest version but the built in android device shows too more version newer than what is showing on the assiatant.

is this problem with the update preventing you from flying? If not, I would ignore the warning

Yes, RC will not connect to AC

take a look , maybe you miss some step

If your device is under warranty, I would send it to check by Dji