djiuser_9DHnIPLLTSiI
lvl.1
Germany
Offline
|
I'm in the same boat.
On top of the USB connection not working, I had a hard time mounting the focus motor,
since the C70 is too high for the focus motor to reach the lens, and the included rod is too short.
I ended up with the SmallRig extended quick release plate #3031
and the SmallRig focus motor rod mount bracket #2851.
Since the C70 is also pretty wide, it was needed to use a halfround file and
widen the screw slot for a millimeter (1/25th of an inch) to the side towards
the gimbal arm, so the C70 could pass the gimbal bracket.
This now works reasonably well mechanically.
The USB port not working though is a constant nuisance.
Michael |
|