Hello.  Does anyone know how to cancel out the 3 user settings for the 3D focus on the RS 2?  I have been doing some tests and used all 3 up and I want them set back to default (never been setup) condition.

Thanks

Am trying to figure this out too

Did you manage to get this to work at all?? If so which lens do you recommend ?

Same problem here, can't reset the 3 lens user settings...

after hours...I finally found out :

First you have to choose the template you want to change. It will asks you to calibrate the motors : do it. at this point you don't access to the 3d focus recalibrate and lenght choose but :
Then go back on the general 3d focus menu, and choose again the obj calibration in the menu at the bottom. It will asks you to calibrate motors again, but this time you'll be able to recalibrate the template you calibrated at first step.
Yeah... Thats silly

Noir Image Posted at 2021-4-20 10:37
after hours...I finally found out :

First you have to choose the template you want to change. It will asks you to calibrate the motors : do it. at this point you don't access to the 3d focus recalibrate and lenght choose but :

I am trying to do this process, but don't see an option for the "obj calibration" in the menu. Can you clarify this a bit? Thanks.