Raven eye was working fine for two days but now suddenly all its 3 light indicators are blinking constantly. I have to long press power button to switch off . I am unable to reset it by pressing power button for 6 times. Earlier when connected to rs2 the three leads used to give charging sequence but now all i can see is three led's blinking. And running gimbal gets disconnected the moment I connect to raven eye.

Hello there, could you please check the app version and the firmware version of the RS2? Please make sure all the version are the latest one noted on this release note:
https://dl.djicdn.com/downloads/ ... lease_Notes_en1.pdf

And please also tell us the camera model you used, we will also report your issue to our engineer to analyze, thanks

DJI Wanda Posted at 12-27 07:16
Hello there, could you please check the app version and the firmware version of the RS2? Please make sure all the version are the latest one noted on this release note:
https://dl.djicdn.com/downloads/DJI_RS_2/20201125/DJI_RS_2_Release_Notes_en1.pdf

Camera model is lumix s1h.  And  firmware are latest release of 25/12/2020 release. But I think the matter is independent of camera make or firmware the issue  it’s the hardware of raven eye itself I am charging it but rather then usual charging sequence of led that blinks one by one all three are blinking. And I am no longer getting gimbal control after connecting to raven eye . Might get it replaced the vendor is generous.

Even though all ports are connected and I can see feed in mobile but no longer I see it in ronin display. Will get a new piece and update

Have a same problem do you find the solution?

Same problem here guys! Anyone come to a solution???

Same problem. Any solutions?

same problem ( yet no solution

Same problem

Same problem

Same problem... chatted with a support guy this morning but can't find a solution... Helppppp