Hey guys, I am having a lot of troubles connecting my Naza m V2 to my computer. I was able to install the driver correctly.
My problem now is, that when I plug the naza into the computer, I get an error message: (see attached files) .
If I now try using the installed driver with the device (driver: https://www.dji.com/at/downloads/products/naza-m-v2) I get this error message: (see attached files)
sorry for the german language. Basically what it says is, that in the chosen folder is no compatible driver for the device. If there is a driver in the folder, make sure that it is based on x64 bit. (which it is)
I followed the instructions of the homepage: https://walkingdroid.com.au/dji-driver-windows-10-naza-m/
I am running Windows 10 Home x64. I've tried both the x32 and the x64 version of the driver but the result was the same.
I was serching for a solution in the internet for days, but I didn't found any information.
Am I doing something completely wrong?
I know you asked this a couple of weeks ago, but have you had any luck?
If not, then you might need to revert to Windows 7 which is a bit more tolerant of new drivers.
If you've got enough hard drive space then you can do this by installing VirtualBox which is free, and then set up a new Windows 7 virtual machine inside of that.
For a basic Windows 7 install you'll need about 25GB.
I used a Windows 7/64 machine yesteday to do this and it worked fine.
I know this was posted almost a year ago, but I too had the problem of getting Windows 10 64-bit to play well with the DJI Driver.
Trying to use it in Windows 8 Compatibility Mode didn't work either.
After some searching and a whole lot of failed attempts I found a video on Youtube titled: by a user named Painless360 (Copy of Link to follow)
https://www.youtube.com/watch?v=YxE6fEBaCaY
The directions are easy to follow and this absolutely did work for me!
Hoping it is of some value still for any of the diehard users of the Naza M...
lvl.1
New
