Dear all ,

i have one question about the (( Zenmuse H3-3D Gimbal )) yestrday i fixed the gimbal with phantom 2 2.0 but i have one probliem

not come in line like this



but it come like this ?? why




why not come line street ?? we need any upgrade or install ??

Plug the transmitter ON, the gimbal its in 45º because the craft its in failsafe...

Hi,

Can you describe more details about the process of your self-test?

DJI-Autumn Posted at 2014-11-24 17:57
Hi,

Can you describe more details about the process of your self-test?

yes about the gimbal when i,m starting the phantom 2 v2.0 it come 0C AFTER 2  SECNENT COME 45C , why i dont no , in remote control when i move to up ok it come but we need to press, some body they told me this for new model 2.0 we need to press up , so i need to ask orady come like this 45C , Or we need install in program dji

this is only infrom you .

waleed

Ask colleague for advise → Calibrate the SE Channel in Ass to see if it helps.

I'm having the same problem and I am not in failsafe

kernst911@gmail Posted at 2014-12-6 07:14
I'm having the same problem and I am not in failsafe

Try  "Basic"-"RC"- Sticks Monitor set to NORM

After then "Advanced" - "Gimbal" with vertical limit set to -30 or -15 or if you wish 0

greetings from the Netherlands
Ko

Try  "Basic"-"RC"- Sticks Monitor set to NORM

After then "Advanced" - "Gimbal" with vertical limit set to -30 or -15 or if you wish 0

greetings from the Netherlands
Ko

Try  "Basic"-"RC"- Sticks Monitor set to NORM

After then "Advanced" - "Gimbal" with vertical limit set to -30 or -15 or if you wish 0

greetings from the Netherlands
Ko