djiuser_g2VkrietJXul
lvl.3
Flight distance : 13294426 ft
United States
Offline
|
djiuser_g2VkrietJXul Posted at 1-4 03:53
I'm just gonna let the pics and video do all the explanation. If you keep in mind that the entire head of the drone cut out in the case from motor cut outs to nose tip is the same flat level in the case Notice where the ridge starts and stops as well. Just as it sits on this flat mirror is as it would sit in a flat bottom case if it needed to as in such case as I have. As far as the props are concerned it might as well be a totally flat case just like my flat bottom MPP Fly more case I modified and use for the Mini. Theres nothing more that the flatness of the bottom of the case can do than this flat mirror, EVEN IF IT REACHED but it doesnt even.. Then as you can see the that grey tape on the mirror would be where that raised edge/red line starts and stops. Any other way of folding them than directly across as you see will bend them at all random places depending on they lay each time. Start out with the design of the case and drone body lines. The red mark represents the grey tape i
The red mark represents the grey tape i used. Blades running directly under motors precisely. The raise in the case is 1/2 inch. The motors and prps and velcro thickness only 1/4 inch. The props never touch bottom in the fly more case this way. What all this means is that ANY OTHER WAY is bad news
https://linksharing.samsungcloud.com/nafrqrJSpH6r
https://youtu.be/cuGPaCuksek
https://youtu.be/UGYaGyWJG_I
https://youtu.be/uiFHdxhmSFw
https://youtu.be/Vkya7c-PMxs
https://youtu.be/VlvU22-BpwQ
https://youtu.be/V8TXJyoI4WU
|
|