Added deep sleep mode. The gimbal enters deep sleep mode after 10 minutes in normal sleep mode. Normal sleep mode is triggered by pressing the power button once or twice. In deep sleep mode, brightness of touchscreen is at lowest setting and USB-C ports, RSA ports, and Bluetooth on gimbal are switched off. Press power button once or twice to exit deep sleep mode. Note that gimbal will not enter deep sleep mode if normal sleep mode is entered through Ronin app or due to gimbal motor stalling.
Added ability to set shutter speed, pan and tilt axis control, smoothness, and reverse direction for front dial.
Added ability to take photos and autofocus for Z CAM E2, Z CAM E2-F6, Z CAM E2-F8, Z CAM E2-M4, and Z CAM E2-S6. To use autofocus, press halfway down on camera control button of gimbal.
Optimized grip rotation in portrait mode and in flashlight mode when using pan follow, pan and tilt follow, or FPV.
Fixed issue: gimbal motor failed to stabilize when using manual lens on Z CAM.
Fixed issue: screen flickered when gimbal motor stalled.
Notes:
Make sure that the DJI Ronin app is the latest version when updating the firmware.
Update the firmware using the DJI Ronin app by connecting the DJI RSC 2 via Bluetooth. Do not disconnect the DJI Ronin app and DJI RSC 2 during the update process.
Update the firmware for the DJI RavenEye Image Transmission System using the DJI Ronin app by connecting the RavenEye via Wi-Fi. Do not disconnect the DJI Ronin app and DJI RavenEye Image Transmission System during the update process.
If DJI RSC 2 has a camera attached and is powered on while updating the firmware, make sure to protect the camera and lens as the motors will power off during the update.
If the firmware update fails, restart DJI RSC 2 and retry.
DJI Stephen Posted at 1-28 19:36
Hello there Montfrooij. Thank you for the reply and you are very much welcome. Again thank you for your support and please stay safe always.
This mornng I realised that the gimbal makes quite often strange fine vibration during shooting. Even shows information about worng calibration on its display.
I made a complet recalibration but I heard and felt it (heard it) again.
With last firmware I didnt have this kind of issues
DJI Stephen Posted at 1-28 19:36
Hello there Montfrooij. Thank you for the reply and you are very much welcome. Again thank you for your support and please stay safe always.
Hi Stephen,
Setting manual end points does not work. The motor isnt limited by it and continue to rotate the focus ring on my sigma 18-35.
What am I doing wrong?
djiuser_TI6hZVxU2717 Posted at 2-2 20:25
Hello. Someone tried the orbit folow option. I did the firmware update but I can't figure out what ORBIT FOLLOW is used for.
Yep, would be good to have a little more explanation as to how the 'orbit follow' works and interacts?! ...
Found this on DJI twitter:
Orbit follow mode: offer more smooth footage when user do orbit shot
This is the tweet: https://twitter.com/DJISupport/status/1354704164715020288
I updated the firmware and now on Canon 90D, after turning off the recording, the mirror closes and opens again. Previously, the recording simply stopped, the mirror was closed only after switching to sleep mode or turning off the stabilizer.