This is the first time that any of my DJI products have gone terribly wrong.

I am transitioning from a Lightbridge Setup to a 5.8 on my S1000 rig, I have upgraded the firmware but am now having trouble getting any commands to the A2 itself.

all channels in the assistant reset to 1 and I am unable to change any of them.

Any help or advice would be appreciated
I am unable to calibrate the FC

Error

Remove batterie and usb cable.
Use a servo cable make a bridge from F1 to F2 ; power on the A2 by Batterie , ignore any beep, - this is a hard reset!

connect over usb to your PC and flash the update again ( use update all button)

Remove the servo cable from F1 and F2  ; disconnect usb cable and batterie.

Try, if it fixed.

knarfboy Posted at 2015-7-10 23:32
Remove batterie and usb cable.
Use a servo cable make a bridge from F1 to F2 ; power on the A2 by Ba ...

Hooray, Its working. Thanks Knarfboy