Wardword Posted at 3-3 13:13
After thinking about it, I think my mistake was adding the bottom code section in the PDF file to the end of the top section, and that was not required with the new setup info in the README file.

So the final adb functions had been run inside the APP, prior to me running the final .SH file from command prompt.

The SDK referenced in the hack is internal to the S1. It does not matter what OS you are running things on.

BGA Posted at 3-3 13:35
There are no Linux versions of the Robomaster app (well, technically the Android version is a Linux version). But you can run the Windows version under Wine, yes.

You do not need to run the app under Linux to do anything in any case.

"You do not need to run the app under Linux to do anything in any case."

Ok perfect, then I should be able to use the Pi for sure if I don't need to run the app in Linux.

Wardword Posted at 3-3 13:44
"You do not need to run the app under Linux to do anything in any case."

Ok perfect, then I should be able to use the Pi for sure if I don't need to run the app in Linux.

Sorry, now I understand what you wanted to know. You need to run the root script and that requires the Robomaster app. It is possible that you can run the root script on windows then unplug the S1 from the Windows machine and into the RPi and things will still work. I am not 100% sure of that though as I never tried.

BGA Posted at 3-3 13:55
Sorry, now I understand what you wanted to know. You need to run the root script and that requires the Robomaster app. It is possible that you can run the root script on windows then unplug the S1 from the Windows machine and into the RPi and things will still work. I am not 100% sure of that though as I never tried.

Ya so I tried again same result, followed instruction to the letter.

I was able to revert it back to normal no problem again, I guess it's just not meant to be for me.

My RM-S1 was recently purchased new, perhaps DJI changed something, possible new revision of the board, who knows.

But ya I'm giving up in it before my luck runs out.

Wardword Posted at 3-3 16:00
Ya so I tried again same result, followed instruction to the letter.

I was able to revert it back to normal again no problem again, I guess it's just not meant to be for me.

Oddly enough, after the 1st  install failed, when I would boot the robot after I restored the original file.

Both my S1 speaker upon booting, and the music in the app were making a crackling sound.

So I uninstalled the app and reinstalled it, strange enough crackles went away.

The strange part is the Robot would crackle upon booting without the App even being loaded, then I would load the app and the app music was crackling.

Now it's back to perfect silent non crackling function.
Perhaps a fresh App install reset's the robot somehow ?.
I have no clue just describing what happened in case anyone else has a similar issue.

@BGA Did you ever get your Robomaster S1 to connect via QR image from running  the 05_sta_conn_helper.py example from the official Robomaster SDK using the method you described in the thread/zip?

Is it also possible to communicate TCP socket or any method to program in IDLE/PyCharm/VScode etc. without the ROBOMASTER Software running lab mode etc. in e.g. Windows/Mac/Android/Wine ?