coelacanthhh
lvl.1
United States
Offline
|
Hey, I have a super weird situation going on and I can't quite figure it out.
I am trying to run the DJI V2 googles on an Air Unit. This is all fresh equipment, never been used.
The Air Unit barely connects with one bar and extreme (30 seconds plus) latency if it even connects at all. It will usually disconnect after a few seconds. However, if the unit overheats and goes into low-power mode I get a perfect connection with full bars and a crystal clear image. Not exactly sure what is causing it. I have tested every setting in the goggle menu, downgraded and upgraded firmware, factory-reset, etc. I was wondering if anyone else has heard of or experienced the same situation.
Thanks!
|
|