What is the maximum length of a camcorder to use the ronin rsc2 ?
Thank you

I had the same question, for an XA40, after a week of back and forward with DJI Support they sent the following:

Sorry for not being able to reply you earlier.
Theoretically, if the Canon XA40 and lens is below 3KG, the RSC2 can provide stabilization function.
But we are not sure as we haven't tested it.

Below are the measurements for each axis.
You are recommended to contact the local dealer to help you tested if it is able to mount your camera on it.

mann1 Posted at 3-15 04:45
I had the same question, for an XA40, after a week of back and forward with DJI Support they sent the following:

Sorry for not being able to reply you earlier.

Thank you for your reply, even if it's a photo of the rs2 and not of the rsc2,subject of our identical question...
I try to do the same with a rsc2 photo

Just measured the RSC2 and the only difference I can see in Measurement is the one on the image at 16.5cm is 15cm.  I managed to get the Canon XA40 to balance and fit (just), will post later on that setup.

Micheal Mann Posted at 3-24 10:12
Just measured the RSC2 and the only difference I can see in Measurement is the one on the image at 16.5cm is 15cm.  I managed to get the Canon XA40 to balance and fit (just), will post later on that setup.
[view_image]

Please share how the xa40 balance
I wanna buy the ronin s2 for the xa40 if its compatible

this is my post with the XA40 - it balances fine but has no controls from the RSC2 - https://forum.dji.com/forum.php?mod=viewthread&tid=238709