fans97828d9e
lvl.1
United Kingdom
Offline
|
fans75e58f0a Posted at 5-26 09:15
I had this problem and tried all the other solutions others offered, but they did not work. I called tech support (giving them credit for this one). I had earlier adjusted the sticks for manual flight, and that is when the problems happened. I was not able to use the controller at any time in any flight mode (got the controller stick error). Here was my solution: I reset the sticks to the original factory position (I adjusted the screws so the sticks operated originally (before adjusting the screws for manual flight)). Then I calibrated the sticks. The sticks then worked correctly. Then I adjusted the F2 screw for manual flight. And the sticks now work without the error. Pain in the rear end but worth it.
What is the factory position for the screws?
I've tried everything else suggested here and nothing working.
Earlier today the drone stopped responding while doing a trick... came about 1m from the ground as I stopped it with the panic button. Then even in normal mode it stopped moving forward.
I've done the calibration a million times, tried all sorts of different tightening that you would think makes sense for manual mode. Tried turning it on centered - soon as I switch to manual mode it throws the error - tried fully tightening F2 in both, a little loose, full f1, a little loose, fully loose etc etc etc, resetting the factory settings. The error goes away after a calibration or two but as soon as it powers on it comes up again.
I'm wondering if this is because of an electrical issue from using the controller for computer FPV sims - when it's plugged in and turned on, it seems to be continuously charging? |
|