djiuser_lK23fQ5Z7hEe
lvl.2
South Korea
Offline
|
Djimaniac Posted at 4-12 17:29
I dont understand what your asking? If you want to run motors, remove props, and arm motors....then you can throttle up and down to run motors......IF i understand what your wanting to do....if not, discard my comment.
My question was that I only want to make the motor run without flying the drone.
However, the problem was that when I wanted to make the drone's motor run through the controller, the only command I knew was the takeoff command, so I only tried to take off through the DJI GO app.
Therefore, when the propeller was pulled out and implemented, the problem as shown in the picture occurred.
In order to cope with this method, is there anything that needs to be modified by entering developer mode in the DJI Assistant program?? Or I wonder if there is another way.
|
-
error
|