Crashed and repaired my P3Pro; replaced gimbal ribbon cable and reset the roll motor shaft.

Only apparent remaining problem is:

The RC gimbal dial does not actuate the camera's tilt.

Tried the following:
1. No response from the RC gimbal dial.
2. No response from setting the GO app C2 button to tilt camera 90˚.
3. No response from moving the blue dot on GO app next to the shutter button.
4. No response after calibrating the RC.

On startup of the P3P, the gimbal does its dance but I don't see any UP/DOWN movement.

All ideas welcome. 


Crashed and repaired my P3Pro; replaced gimbal ribbon cable and reset the roll motor shaft.

Only apparent remaining problem is:

The RC gimbal dial does not actuate the camera's tilt.

Tried the following:
1. No response from the RC gimbal dial.
2. No response from setting the GO app C2 button to tilt camera 90˚.
3. No response from moving the blue dot on GO app next to the shutter button.
4. No response after calibrating the RC.

On startup of the P3P, the gimbal does its dance but I don't see any UP/DOWN movement.

All ideas welcome.