Have Mavic2 Zoom with less than 30 hours on it.
Suddenly get cannot fly message.
Done the IMU calibration 3 times, no good.
DJI how does it get fixed or do you need to replace whole machine.
In New Zealand so being only 2 years old and under 30 hours flying you need to tell your agents to get it sorted please.

Hello there Rustydfa. I am sorry for the trouble this has caused and thank you for reaching out. Can you please try to re-link your DJI Remote Controller to your DJI Mavic 2 Zoom? In addition can you please try to check the location if it is a No Fly Zone NFZ from our DJI page ( https://www.dji.com/flysafe/geo-map ) for us to be able to isolate the said issue? Thank you.

Still nothing. Get message that “IMU initialising and it goes for minutes then repeats. Message that camera not working flicks on and off.
Not in a no fly zone